Here are a few tips to keep your bike in perfect state and maximize its performance:

Clean your bike 

  • Clean the belt with a wet cloth, a toothbrush or a sponge. Simply clean off any dirt gently with one of those items. 
  • Clean your disks with a cloth - dry or with some alcohol. Don’t use soap as it could damage them.
  • Remove your battery and clean the rest of your bike using a moist cloth. The bike is not approved for steam cleaning, high pressure cleaning or cleaning with a water hose. Avoid spraying water directly on electronics (lights and LED module on your top tube), connectors and wires. You can use a damp cloth or soft brush to remove dirt and grime.

Inflate your tires

To avoid punctures, we recommend you to check your tire pressure and inflate your tires up to 4 bar (model sold in 2019) or 5 bar (model sold in 2018).

Tighten nuts and bolts

Inspect your bike and verify all nuts and bolts are well tightened.

Check your belt tension

Check the belt tension by pressing firmly down on it in the middle with your index finger. The deflection of the belt should be around 0.5 cm to 1 cm. If you have a belt tension measurement tool, the tension should measure around 40 lbs, or between 35 and 50 Hz. If that’s not the case, you can get your belt readjusted at one of our service partners.

You're good to go!

Did this answer your question?